Use a Verizon router connected to ONT via Coax, and then plug an ActionTec MoCA (LAN) bridge, ethernet side to VZ router LAN ports, Coax to house wiring distribution, and then connect up another ActionTec MoCA LAN bridge, Coax to house wiring in room you wan the Nighthawk connected, and then connect the ethernet side to a LAN port on the Nighthawk, and disable DHCP and NAT on the Nighthawk, if you want to use it as an AP only for wifi. You CANNOT connect an ActionTec Moca LAN ethernet bridge to talk MoCA WAN to the ONT. Step3Plug the other end of the Ethernet Cableinto an OPEN Ethernet Port on your Modem/ Router. There's also "MoCA LAN", which the Verizon router also speaks, as well as those ActionTec MoCA ethernet to coax bridge devices you have.Īnd for completeness, you need "MoCA LAN 2.0 Bonded" adapters, to get full gigabit speed out of MoCA, which I'm guessing that you don't have.ītw, if you have Coax from the ONT ("MoCA Wan"), then you NEED a Verizon router, with a Coax connection. Step2Find your Broadband Modem/Router.Plug one end of the Ethernet Cable into the Ethernet Network port on the side of the MoCA Network Adapter. Actiontec ECB6200 Bonded MoCA 2.0 Network Adapter Reviewed Tim Higgins Finders Rankers Charts Access Point Router NAS Mesh Extender Bridge Powerline Router (Old) expand menu Typical Price: 200 Buy From Amazon Introduction This article originally appeared as a post on SNBForums. I am guessing since the signal was split before the bridge, it was sending the traffic directly into the Nighthawk router via coax to ethernet instead of ethernet to coax (which I heard most moca adapters cant transfer the fios signal like this).Īnyways, I am trying to use coax through MI424WR as a bridge into my Netgear router then Moca back to the other rooms of my house using moca adapters, is this possible?įirst, you must realize, that there are different frequency bands used by MoCA.įor Verizon FIOS, there's "MoCA WAN", which is between the ONT, using Coax, to the Verizon router. When I tried doing this I lost internet connection and my computer which was plugged directly into the Nighthawk kept altering between no network cable plugged in, and no internet connection. MoCA (Multimedia over Coax Alliance) 1.1 technology. Since it worked as 2 way traffic before turning the MI424WR into a bridge. I thought this was possible simply by ethernet from LAN port on nighthawk router into the moca adapter back into a splitter that houses the same connection coming in through the MI424WR bridge. My question is whether I can use the Auctiontech moca adapters (ECB2500C) to send the LAN back throughout the house using the coax connection. so I set up the MI424WR as a moca WAN bridge successfully and got the wireless network going. I got a fancy new Nighthawk R8000 router that I would like to use for faster wireless speeds & range, etc. I had my house set up using the Actiontec MI424WR Rev 1 with coax from ONT, I then used some actiontec moca adapters to run the network through the house since it is wired for Coax to ethernet switches which I plugged my IP cams, gaming systems, etc. I recently purchased the Actiontec MoCA 2.0 Ethernet to Coax adapter because my entire house is wired for coax and I recently upgraded to the FIOS Quantum Gateway that also supports MoCA 2.0.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |